Installation Summary; Figure 2: Satellite Router And Related Terminal Components - Hughes HN9400 Installation Manual

Satellite router
Hide thumbs Also See for HN9400:
Table of Contents

Advertisement

Chapter 2

Installation summary

HN9400 Satellite Router Installation Guide
6
1038554-0001 Revision B
This guide explains how to install the HN9400 satellite router. It includes limited information
about other satellite terminal components. The satellite router is the small indoor unit. The
satellite terminal includes the satellite router and the antenna, radio assembly, and IFL cables,
as shown in

Figure 2: Satellite router and related terminal components

Figure 2: Satellite router and related terminal components
This summary focuses on installation of the satellite router, but also includes some information
on related tasks such as antenna installation and pointing. The tasks listed below are the main
installation tasks, but these are not all of the installation tasks.
Complete all steps in the order they are presented in this installation guide unless you have a
specific reason for doing them in a different order. In any case, make sure all steps are completed.
You must install the antenna before the satellite router can be commissioned. Then you point
the antenna as part of the router commissioning procedure.
Details for the satellite router installation tasks are included in later chapters in this guide.
Preparing for the installation
• Make sure you have all items required for installation, including the Installation Reference
Sheet and installation specification, all equipment to be installed, and required tools for the
outdoor equipment.
• Consumer installations only: Make sure the customer's computer meets the requirements
listed in
Computer and networking requirements
• Conduct a site survey.
• Assemble and install the antenna and radio as instructed in the antenna installation guide.
Installing the satellite router
• Connect the transmit and receive cables.
• Connect the router to the installer laptop.
• Connect the power supply.
• Power up the router and observe the LEDs to verify normal operation.
Commissioning the router and pointing the antenna
Preparing for installation
on page 6.
on page 10.

Advertisement

Table of Contents
loading

Table of Contents