Table of Contents
Advertisement
Installing the satellite router
Connecting the power supply
Connecting an AC/DC power supply
The LAN LED on the front of the router should now be on.
Follow the instructions in
Connecting an AC/DC power supply
assembling a DC/DC power supply
• The input must be 120-240 VAC.
• A suitable surge protector is recommended to protect the router from possible damage due
to power surges.
The customer provides the surge protector. If a surge protector or power strip is not present, use
a wall outlet or other power source.
In some countries, the router may use a replacement AC power cord. Different countries have
different standards and requirements that must be observed.
Before connecting the router power supply to the AC power source (using a surge protector),
use an AC outlet tester to verify that the power outlet is wired correctly. Wiring problems may
include:
• Hot and neutral wires reversed
• Neutral and ground wires reversed
• Open ground (incomplete connection)
• Open neutral
If the outlet is wired improperly, notify the customer that you are not permitted to connect the
system to a faulty outlet. Do not proceed with the installation until a properly wired outlet is
provided.
Connect the power supply as follows:
1. Check
Power supply information
2. Connect the DC power cord to the DC IN port on the router, as shown in
an AC power supply
on page 20.
DC power cord, the satellite router may not perform properly and could be damaged.
3. Connect the AC power cord to the power supply.
Do not connect the AC power cord to the surge protector at this time. Wait until you are ready
to observe the router's LEDs upon power-up, as explained in
21 and
LEDS on power-up
on page 21.
on page 20.
The following apply to the AC/DC power supplies:
on page 9 to make sure you have the correct power supply.
If you apply power to the power supply and then connect the
HN9400 Satellite Router Installation Guide
Chapter 3
on page 19 or
Connecting and
Figure 7: Connecting
Powering up the router
on page
1038554-0001 Revision B
19
Advertisement
Table of Contents
Troubleshooting
