Printronix P8000 Series Administrator's Manual page 72

Vert Forms (LG)
•
Bot Frm 66/6 (factory default). This option sets the bottom margin for the forms. You must specify the
bottom margin in lines (at 6 lines per inch), ranging from 0 to 198 lines (33 inches). The default setting
is 66. Press the right arrow to increase the value, left arrow to decrease the value, and ENTER to
change units. Selecting a value for this option resets the top margin to 0, so the top margin must be
redefined after this option is selected.
•
Top Mrg 6/0 This option sets the top margin for the forms. You must specify the top margin in lines
(at 6 lines per inch), ranging from 0 to 198 lines (33 inches). The default setting is 0. Press the right
arrow to increase the value, left arrow to decrease the value, and ENTER to change units. The
margins will automatically adjust so that the top and bottom margins do not cross each other.
Horiz Forms (LG)
•
Left Mgr 0.00 (factory default). This sets the left margin for the forms. You must specify the left
margin in 1/10 inch increments, from 0 to 13.1 inches. The default value is 0. Press the right arrow to
increase the value, left arrow to decrease the value, and ENTER to change units. The margins will
automatically adjust so that the left and right margins do not cross each other.
•
Right Mrg 13.2. This sets the right margin for the forms. You must specify the right margin in 1/10
inch increments, from 0.1 to 13.2 inches. The default value is 13.2. Press NEXT to increase the
value, PREV to decrease the value, and ENTER to change units. The margins will automatically
adjust so that the left and right margins do not cross each other.
Page Length Rep (PCL-II)
•
Inches/Page (factory default). Allows the user to set the page length in inches.
•
Lines/Page. Allows the user to set the page length in number of lines.
Max Line Width (PCL-II)
Set the maximum line width at either 13.2 inches or the maximum width of the printer.
LPI Adjust (PCL-II)
Set the lines per inch value for the PCL-II emulation.
Resolution (OpenPrint)
This parameter defines the default print resolution. This selection is used when either the print resolution
is not defined by the data stream or if the print resolution defined by the data stream is not supported.
The following resolutions are available on OpenPrint P8000 Standard:
•
120x144 DPI (factory default)
•
90 x 96 DPI
The following resolutions are available on OpenPrint P8000 HD:
•
180x180 DPI (factory default)
•
180x90 DPI
•
90x180 DPI
•
120x120 DPI
•
90x90 DPI
72