Printronix P8000 Series Administrator's Manual page 266

Displayed Message
PAP INVLD PARM*
PAPER REQUESTED
Install A4
PARITY ERROR
PLAT INV CMD*
PLAT INV PARM*
PLAT INV STATE*
PLEASE WAIT...
RESET IN PROGRESS
POWER SUPPLY HOT
PRINTER HOT
PRINTER UNDER REMOTE
CONTROL
PROCESSOR HALTED
EC_FAULT_RTSYS2
266
Table 23 LCD Message Troubleshooting Table (ASCII)
Can User
Correct?
No
Yes
Yes
No
No
No
N/A
Yes
Yes
No
No
Explanation
Paper Invalid Parameter.
Firmware error on
controller board.
A paper size mismatch is
detected.
The printed output may
contain a random ?
(question mark)
characters.
Platen Invalid Command.
Firmware error on
controller board.
Platen Invalid Parameter.
Firmware error on
controller board.
Platen Invalid State.
Firmware error on
controller board.
Status message: the
printer finished loading
the program into flash
memory and is
automatically resetting
itself.
Power supply sensors
report high temperatures.
This message indicates
internal temperatures of
80° Celsius or higher
(176° Fahrenheit).
Status message: The
printer is under the
control of PrintNet
Enterprise (PNE) remote
management software.
Real-time System
Firmware error on
controller board.
Solution
Contact your authorized
1
service representative.
Check the paper size setting
and if necessary, load new
media and change the
paper size menu option.
Check your printer serial
interface parameter settings;
if necessary, adjust them so
that they match the settings
of the attached host.
Contact your authorized
1
service representative.
Contact your authorized
1
service representative.
Contact your authorized
1
service representative.
No action is required.
Check printer environment. If
hot or dusty, relocate printer.
Contact your authorized
service representative if this
1
occurs frequently.
Check printer environment. If
hot or dusty, relocate printer.
Contact your authorized
service representative if this
1
occurs frequently.
No action is required.
Contact your authorized
1
service representative.