Printronix P8000 Series Administrator's Manual page 173

•
Enable. The Linefeed moves to the next line as calculated from the Top of Form position, thereby
retaining vertical text alignment. When printing graphics or bar codes, you may want to set the PTX
Linefeed parameter to Enable to maintain text alignment.
PTX Linefeed Enabled
LINE 1
LINE 2
LINE 3
LPI Adjust
This parameter lets you specify the lines per inch (lpi) values: 6 LPI (factory default) or 8 LPI.
Page L./Lines
This parameter lets you set physical page length in lines from 12 to 96 at 6 lpi, or 16 to 128 at 8 cpi. The
default is 66 lines at 6 lpi.
NOTE: If 6 lpi is selected, you will be able to scroll the menu to 128 (an invalid length). However, when
you press ENTER to select this value, the menu will return with the maximum lines for 6 lpi (i.e.,
96 lines). Similarly, selecting too few lines for 8 lpi will cause the menu to return with 16 lines.
Page L./Inches
This parameter allows you to set physical page length from 2 to 16 inches, in increments of half an inch.
The default is 11 inches.
Config Print
This option prints the emulation's parameters and the currently selected values.
Symbol Set Print
This option prints a list of all the available sets. The character set number prints to the left of the character
set sample.
Reset Cmd CFG Ld
When the printer receives a host data stream reset command in addition to resetting printer variables, the
selected configuration will be loaded.
•
Current Config (factory default). If you have preset and presaved multiple configurations, then the
currently selected presaved configuration is loaded when the reset command is received.
•
Factory Config. The factory installed configuration is loaded when the reset command is received.
•
Disable. The printer ignores the reset command when it is received and continues to use the
currently loaded configuration.
•
Power-Up Config. The power-up configuration is loaded when the reset command is received.
Linefeed
PTX Linefeed Disabled
LINE 1
LINE 2
Linefeed
LINE 3
173