Arabic Context Analyzer - Printronix P8000 Series Administrator's Manual

•
= CR + LF. Each time the printer receives a Line Feed, it inserts an additional Carriage Return code
(hex 0D) into the data stream. This feature can be used in most installations, but it is required if the
host computer does not send Carriage Returns to the printer.
FF
This parameter forces the printer to insert an automatic Carriage Return code into the data stream
whenever a Form Feed code occurs. This can be used in most installations, but it is required if the host
computer does not send carriage returns to the printer.
•
= FF (factory default). Does not perform an automatic carriage return. The next print position will be
the current print position of the next form.
•
= CR + FF. Performs an automatic carriage return. The next print position will be print position 1 of
the next form.
Unsolicited Rpt
This option enables or disables Printer Device Status Reports to be sent to the host when a reportable
status or error condition has occurred.
•
No (factory default). Disables all unsolicited status reports from the printer.
•
Small. Enables brief unsolicited status reports and sends an extended status report to the host.
•
Big. Enables extended, unsolicited status reports and sends an extended status report to the host.
Print Mode Opt
When enabled, this option affects the SPI, SHS, and DECSHORP commands. The printer will no longer
be forced into these commands and print speed improves significantly when in portrait orientation. For
SHS and DECSHORP, the character size will change with the selected pitch. In addition, SGR attributes
such as bold, crossed-out, and italics, will be done in print mode with greater efficiency.
•
Enable (factory default). Enables the print mode option.
•
Disable. Disables the print mode option. This provides compatibility with older LG printer products.
Plot Mode Opt
•
When enabled, this option will plot with greater efficiency, particularly with respect to the Postnet
barcode. Postnet is printed in the same density as the current print mode font so that reverse motion
will be inhibited when possible.
•
Enable (factory default). Enables the print mode option.
•
Disable. Disables the print mode option. This provides compatibility with older LG printer products.
I-2/5 Guard Bars
•
Enable (factory default). Horizontal guard bars are printed above and below each Interleaved 2/5 bar
code. This option only applies to Interleaved 2/5 bar codes.
•
Disable. Interleaved 2/5 bar codes are printed normally, with no guard bars.

Arabic Context Analyzer

The Arabic firmware offers outstanding performance in terms of Arabization features and is intended for
applications requiring Arabic and Latin high print quality under different Arabization platforms. It supports
many Arabization mechanisms and many Arabic and Latin code sets.
177