Define LF Code
The Define LF code option controls the action of the printer when it receives a Line Feed code (hex 0A)
from the host computer. If this feature is enabled, each time the printer receives a Line Feed, it inserts an
additional Carriage Return code (hex 0D) into the data stream. This feature can be used in most
installations, but it is required if the host computer does not send Carriage Returns to the printer.
•
LF = CR + LF (factory default). Adds an extra Carriage Return with each Line Feed.
•
LF = LF. Does not add a Carriage Return with a Line Feed.
Printer Select
•
Disable (factory default). Ignores the ASCII DC1 and DC3 control codes.
•
Enable. Disables the printer when a DC1 control code is received, and enables the printer when a
DC3 control code is received.
Alt. Set 80-9F
•
Control Code (factory default). Interprets data in the range of hex 80 through hex 9F as a control
code.
•
Printable. Prints data in the range of hex 80 through hex 9F.
Emulation Extend
•
Disable (factory default). Does not select the extension command.
•
Enable. Selects the extension command (ESC 4/ESC 5 to select/cancel Italic Printing and ESC SP to
select Intercharacter Spacing).
KSSM Emulation
Printer
Protocol
KSSM
(from page 110)
Character
Sets
Standard Sets*
CR = CR*
IBM PC*
CR = CR + LF
Epson Set
20 CPI
Condensed
Enable*
Disable
112
Define CR
CR Bold
Code
Select
Enable*
Disable
Alt Set 80-9F
Control Code*
Printable
Define LF
Autowrap
Code
With LF+CR*
LF = CR + LF*
With CR
LF = LF
Disable
Printer
Select
Disable*
Enable