Printronix P8000 Series Administrator's Manual page 257

Table 23 LCD Message Troubleshooting Table (ASCII)
Displayed Message
CARTRIDGE NOT SEATED
Re-install Cart
CARTRIDGE/REGIO
N X MISMATCH
Use Correct Cart
CARTRIDGE/ SHUTTLE
MISMATCH
Use Correct Cart
CARTRIDGE/TIPSIZE
MISMATCH
Use Correct Cart
CATASTROPHIC ERROR
D50 STATUS
UPGRADING PANEL
D51 STATUS
PROGRAMMING DONE
DIAGNOSTIC PASSED
DO NOT POWER OFF
Can User
Explanation
Correct?
Yes The ribbon cartridge is
not properly positioned.
Yes The incorrect cartridge
type is being used for
the printer. "X" indicates
the region of the printer.
Yes This message displays
when an Extended Life
Cartridge is mounted on
a 500 lpm printer.
Yes The incorrect cartridge
type is being used for
the printer.
No Fatal error in printer.
No Status message: The
printer is upgrading the
panel, where %XX
represents the
percentage completed.
No Status message: The
printer is loading
firmware, where %XX
represents the
percentage completed.
No Status message: the
printer passed its
memory and hardware
initialization tests.
No Status message: The
printer is performing an
operation that must be
completed before you
can cycle power.
Solution
1. Make sure a ribbon
cartridge is installed in
the printer.
2.
Make sure the ribbon
cartridge is seated
properly.
3.
Remove and replace
the cartridge if
necessary.
4.
Contact your
authorized customer
service representative.
Install Region X ribbon
cartridge in the printer.
NOTE: Specify the region of
the printer when
ordering ribbons.
Install Standard Life Cartridge.
Install the correct ribbon
cartridge type in the printer.
Contact your authorized
customer service
1
representative.
No action is required.
No action is required.
No action is required.
No action is required, but do
not power off the printer until
the operation is complete.
1
257