Printronix P8000 Series Administrator's Manual page 168

Barcode Quality
This parameter chooses the horizontal print quality of barcode labels.
•
High (factory default). Label is printed at 144 dots per inch.
•
Select By Host. The application decides the quality of the labels.
•
Low. Label is printed at 72 dots per inch.
Barcode Speed
This parameter chooses the vertical print quality of barcode labels.
•
High (factory default). Barcodes are printed with less vertical dots, increasing printing speed, but
decreasing print quality.
•
Select By Host. The application decides the quality of the labels.
•
Low. Barcodes are printed with more vertical dots, decreasing printing speed, but increasing print
quality.
Early Print Comp (Complete)
This parameter chooses when to send a Print Comp to the controller.
•
Off (factory default). Print Comp is sent if page is printed completely.
•
On. Print Comp is sent immediately. The next page will be created. This improves the print
performance when starting the next page.
NOTE: When Early Print Comp is enabled and an error occurs, you may lose data.
Graphics Scaling
This parameter chooses the scaling factor for graphics when the Mapping Control option of the IPDS
Write Graphics Control command is SCALE TO FIT:
•
Rounded (factory default). Calculations are rounded up in the desired output resolution.
•
Exact. Graphics will be scaled as accurately as possible.
I2/5 Checksum
This parameter defines the printer checksum calculation method for Interleaved 2 of 5 barcodes.
•
Standard (1/3) (factory default). The odd numbers will be multiplied by 3 and the even numbers by 1
for calculation of the checksum.
•
Special (4/9). The odd numbers will be multiplied by 4 and the even numbers by 9 for calculation of
the checksum.
NOTE: "Odd" refers to the 1st, 3rd, 5th... character in the barcode, while "even" refers to the 2nd, 4th,
6th... character in the barcode.
Default Code Page
Choose which code page to use with the IPDS emulation.
Code Page Subset
When the Thai code page is selected as the default, either from the front panel or by a host command,
you may choose from three different versions.
168