Printronix P8000 Series Administrator's Manual page 100

Translation Tbl
Prints out a table of the TN5250 interface's current character set. This operation is valid only when the
TN5250 interface is the current interface.
Active Char Set
Selects which group of character sets (Primary or Secondary) will be active.
•
Secondary Set (factory default)
•
Primary Set
Prt Partial Line
•
Enable (factory default). When this option is enabled, it forces the printer to print if a partial line is in
the printer (i.e. line not ending with a LF).
•
Disable. When disabled, the last partial line of data will not be printed.
PTX Transparent
Lead-in Chars
You can enable additional printer features which are not accessible through standard TN5250 emulations.
To access these features, send text commands in the data stream. The commands must have a start and
end code. Four sets are available:
•
Set 1. start code: <% (factory default)
stop code: >
• ¬¬
Set 2. start code:
stop code: $
•
Set 3. start code: _%
stop code: _
•
User Defined.
Usr Defined HTRN
This option is used to set user defined lead-in characters. The range is ASCII character. This option
allows users to define their own lead-in characters for the Printronix Specific commands. Select a hex
value for the following codes for the User Defined option:
•
Start Code 1 5F (factory default)
•
Start Code 2 5F
•
Stop Code 5B
Alt. Set 80-9F
•
Printable (factory default). Prints data in the range of hex 80 through hex 9F.
•
Control Code. Interprets data in the range of hex 80 through hex 9F as a control code.
Graphic Chek Err
Allows overriding of the host setting for the SGEA (Set Graphic Error Action) command.
•
Enable (factory default). The host setting for the SGEA used by the printer. If the SGEA command is
requested to stop on graphic errors, the printer will stop when a graphic error is detected.
100