Printronix P8000 Series Administrator's Manual page 254

Displayed Message
12 VOLT FAILED*
B12 ERROR:
PROGRAM MISSING*
B13 ERROR:
NOT
COMPATIBLE*
B20 STATUS :00%
DOWNLOAD MODE
B21 STATUS:
PRINTER RESET
B22 ERROR:
DECOMPRESS SIZE*
B23 ERROR:
DECOMPRESS CKSUM*
B30 STATUS:
INITIALIZING..
.
B50 STATUS:
PANEL CODE BAD
B51 STATUS:
XX% LOADING...
Bxx ERROR: NO
DOWNLOADER FOUND
254
Table 23 LCD Message Troubleshooting Table (ASCII)
Can User
Correct?
No
Yes
No
No
No
No
No
N/A
No
No
No
Explanation
The power supply 12 volt
output has failed.
The printer does not see
a program in flash
memory.
Attempting to download
a program that is not
compatible with the
printer.
Status message
informing the operator
that software is being
downloaded. Percentage
figure indicates
approximate amount
loaded into the printer.
Status message
informing the operator
that the printer is
undergoing a system
reset.
FLASH memory has not
passed boot initialization
tests.
FLASH memory has not
passed boot initialization
tests.
Status message: the
printer is running its
initialization routines after
startup and successful
memory tests.
Saved version of Panel
Code is corrupt.
Status message: printer
boot-up routines are
loading printer system
software into flash
memory and SDRAM.
No Downloader was
found while downloading
a file.
Solution
Contact your authorized
1
service representative.
There is no program in
printer memory. Download
printer firmware again.
Cycle power to see if the
message clears, if not,
contact your authorized
1
service representative.
No action is required.
No action is required.
Cycle power to see if the
message clears, if not,
contact your authorized
1
service representative.
Cycle power to see if the
message clears, if not,
contact your authorized
1
service representative.
No action is required.
Reload released Firmware.
No action required.
Reload released Firmware.