Printronix P8000 Series Administrator's Manual page 207

message "EXCESS RBN WEAR / Install New RBN", printing will stop and the user must install a new
ribbon before printing can resume.
NOTE: The excess ribbon wear is set below the "Lighter -10" Ribbon End Point setting.
Print Energy (1000 lpm only)
This menu allows the user to optimize energy or impact of the hammers when printing single or multipart
forms.
•
Standard (factory default). When this factory default option is selected, the printing energy is
optimized for normal jobs.
•
PowerPrint. When this option is enabled, printing is optimized for multi-part forms.
Disp. Intensity
This menu controls the intensity of the LCD display. The range is 0-20 and the default setting is 2.
Program select
This menu is available only with the ASCII bundle firmware and allows the selection of the active
program. Choosing an active program will require the printer to reload its firmware causing all saved
configurations to be lost. The process will take three to five minutes. Program Files are stored in the Flash
Files System and can be deleted if more space is need in the Flash File System. Once the file has been
deleted, the program will no longer appear in the Program Select menu. If all of the Program Files are
deleted this menu will no longer be shown. The programs in the ASCII bundle firmware:
•
IPDS/PGL/VGL/LP+
•
TN 3270/5250
•
ANSI
•
PCL-II
207