Printronix P8000 Series Administrator's Manual page 144

Received DEL
•
Observe (factory default). A DEL code received from the host is handled as a Delete command.
•
Ignore. A DEL code received from the host is ignored.
Private Mode
Determines the default type of character set (Set 1 or Set 2). This can also be set by ESC sequences
ESC [>5h and ESC [>5l. Refer to these descriptions in the ANSI Programmer's Reference Manual for
further details.
Pos. on BC/OvrSz
•
Set to top (factory default). The paper is fed back to the top of barcodes or oversized characters after
they are printed. This allows printing on the same line.
•
Set to bottom. The printer will continue printing without backing up.
BC Check Digit
•
By host (factory default). The host calculates the barcode check digit and sends it along with the
barcode. The check digit is not verified by the printer but printed as it was received.
•
By printer. The barcode is sent without the check digit, and the printer calculates and adds it in.
Barcode Darkmode
•
Enable (factory default). The barcodes are printed at a higher resolution.
•
Disable. The barcodes are printed at lower resolution but at a higher speed.
PUM Default
This is the Unit of Measure (UOM) as it is used within the ANSI emulation. Coordinates received in ESC
sequences can be sent in two UOMs:
•
Decipoints (factory default). A unit of 1/720 inch
•
Lines or columns. Uses the current LPI and CPI values. The UOM used is determined by this
configuration setting.
Truncate PI Slew
•
Truncate at TOF (factory default). The slew is terminated when the next Top-of-Form is reached.
(This function applies to the ANSI EVFU only.)
•
Disable. PI slews will be completed independent of their length.
ETX/ACK
End of Text/Acknowledge. The host controls the flow of communication to the printer by sending a block
of data and ending the block with an End of Text (ETX) signal. When the printer receives the ETX signal,
it acknowledges the ETX, thereby acknowledging it has received the entire block of data.
•
Disable (factory default)
•
Immediate
•
Afterprint
144