Printronix P8000 Series Administrator's Manual page 318

Table 27 PTX_SETUP Commands (Non-Platform Specific)
Command
CONFIG
LP MODE
FILE_IO
(DISK_IO)
318
Sub-Command
PANEL
PNE_PROT_NUM
PXML_PORT_NUM
n/a
CAPTURE
DRIVE
Parameter
This command locks the operator
LOCK
out of the printer's configuration
menu.
UNLOCK
This command unlocks the printer's
configuration menu and allows the
operator access to the menus. By
default, the menu is unlocked.
This command sets the Port
Port Number
Number the PNE uses to
communicate to the printer if the
PNE Port was set to Ethernet. This
command causes the printer to
automatically reboot.
This command sets the Port
Port Number
Number the PXML and UCP will use
to communicate to the printer if the
PXML Port is set to Ethernet. This
command causes the printer to
automatically reboot.
Protocol Protocol must be 0-4. This
command resets the software
protocol, and is selected as follows:
0 - P-Series
1 - P-Series XQ
2 - Serial Matrix
3 - Proprinter III XL
4 - Epson FX-1050
Filename Captures all incoming data into a file
named Filename. Receipt of a
FILE_IO–CAPTURE command
without the Filename parameter will
force the file data to be written to
flash, and will end the file capture.
Letter This command is parsed for
backwards compatibility. However,
since the flash file system is a single
device, the drive letter will be
ignored.
Description