Printronix P8000 Series Administrator's Manual page 260

Displayed Message
ERROR OCCURRED
FLUSHING QUEUES*
ERROR NOR FLASHED
WAS
NOT CLEARED
ERROR: DC PROGRAM
NOT VALID
ERROR: LOCKED
SN=nnnnnnnnnnnnnnnnnnnn
n
ERROR: NVRAM FAILURE
ERROR: PROGRAM NOT
COMPATIBLE
ERROR: PROGRAM NOT
VALID
ERROR: SECURITY KEY
NOT DETECTED
ERROR: WRONG
CHECKSUM
ERROR: WRONG OEM
260
Table 23 LCD Message Troubleshooting Table (ASCII)
Can User
Correct?
Yes
No
Yes
No
No
Yes
Yes
No
No
No
Explanation
An interim message that
displays while the printer
discards host data it
cannot use because a
fault condition exists.
While this message
displays, the asterisk (*)
rotates.
Problem programming
Boot Code.
The printer cannot find
the data controller
program or the validation
checksum is corrupt.
nnnnnnnnnnnnnnnnnnnn
n is the serial number of
the printer's security key.
The SPX serial number
does not match the
printer's serial number
and cannot be used with
the printer.
The non-volatile SRAM
on the controller board
has failed.
The printer is not
compatible with the
downloaded program.
The printer does not see
a program in flash
memory.
The security key is not
present or failed.
The printer received the
complete program but
the checksum did not
match. The data may
have been corrupted
during downloading.
The SPX inserted in the
debug port is not
intended for this model
printer or this OEM.
Solution
Wait. When the asterisk (*)
stops rotating, a different
fault message will appear:
troubleshoot the final
message.
Contact your authorized
1
service representative.
Download the program again.
If the message appears,
contact your authorized
1
service representative.
Contact your authorized
1
service representative.
Contact your authorized
1
service representative.
Use the correct emulation
software options(s) for this
printer model.
There is no program in
printer memory. Download
the emulation.
Contact your authorized
1
service representative.
Contact your authorized
1
service representative.
Contact your authorized
1
service representative.