Chapter 2. Installation Instructions; Introduction; Installation Policies - Cleveland steamcraft 21-CET-8 Service Manual

INTRODUCTION

INSTALLATION POLICIES

CHAPTER 2. INSTALLATION INSTRUCTIONS

This chapter is a guide for installation of the SteamCraft 3.1, model number
21-CET-8. The instructions are written for qualified, professional plumbers,
pipe fitters, and electricians. This guide does not include all procedures and
precautions in the common domain of licensed plumbers, pipe fitters, and
electricians, or experienced food service equipment installers. These
instructions must be used in conjunction with a thorough understanding of
the Basic Plumbing Code of the Building Officials and Code Administrators
International, Inc. (BOCA), the National Fuel Gas Code, ANSI Z223.1-
1984, and the Food Service Sanitation Manual of the Food and Drug
Administration (FDA).
Before starting installation, the owner and the installer should read through
this chapter and thoroughly understand and agree upon:
• The installation policies of Cleveland Range, Inc. as stated in Installation
Policies.
• Responsibility for electric power requirements as described in
Preparation for Installation, Electric Power Requirements.
• Responsibility for feed water quality and its testing as described in
Preparation For Installation, Water Quality Requirements.
• The SteamCraft 3.1 must be installed by qualified plumbing and electrical
personnel, working to all applicable national and local codes. Equipment
installation must comply with the Basic Plumbing Code of the Building
Officials and Code Administrators International, Inc. (BOCA) and the
Food Service Sanitation Manual of the Food and Drug Administration
(FDA).
• Cleveland Range designs and manufactures equipment to comply with
applicable standards for manufacturers. Included among these
certification agencies are: UL, A.G.A, ASME/N.Bd, NSF, CSA. CGA,
ETL, and others.
Model 21-CET-8 Service Manual
WARNINGDEATH, INJURY, AND
EQUIPMENT DAMAGE
DEATH, INJURY, AND EQUIPMENT DAMAGE could result
from improper installation of the SteamCraft 3.1, or from
installation of a unit damaged during shipment or storage.
Either of these conditions could also void the equipment
Warranty.
DO NOT INSTALL
a SteamCraft 3.1 suspected of
damage.
Install the SteamCraft 3.1 according to the policies and
procedures outlined in this manual.
WARNING
Page 3