Surface Mounting And Leveling - Cleveland steamcraft 21-CET-8 Service Manual

Figure 2-8. Counter
Holes
2. Be sure electric power is turned off at the main power switch. Place the
SteamCraft 3.1 on its left side.
3. Screw the four legs into the weldnuts mounting boles. All four legs must
be installed for proper mounting of the SteamCraft 3.1.
4. Place the steamer upright on its four legs.
Positioning and Leveling
1. Thoroughly clean the counter top area that will support the steamer.
2. Using a level, determine and mark the highest comer of the counter top
area that will support the steamer.
3. Lift the SteamCraft 3.1 into position on the counter.
4. Do not adjust the retractable foot of the leg in the highest comer (marked
in step 2). Using a level, adjust the other three legs until the unit is level
both front to back and side to side.
5. After the SteamCraft 3.1 has been positioned and leveled, refer to page
14, and install the slide racks.

Surface Mounting and Leveling

When a SteamCraft 3.1 is surface mounted (without legs), NSF standards
require a sanitary counter top seal between the counter surface and the
bottom of the unit This seal closes any gap between the unit and counter
top. A sanitary seal closing a gap greater than 1/4 inch may not meet NSF
sanitation standards. Therefore, do not surface mount the SteamCraft 3.1 to
a surface out of level more then 1/4 inch over the length or width of the unit.
Shimming the unit level may leave a gap too large to seal within NSF
standards.
1. Thoroughly clean the bottom perimeter of the steamer and the counter top
area that will support the steamer.
2. Using a level, determine and mark the highest comer of the counter top
area that will support the steamer. At each of the other three comers,
measure and note the shim thickness required to level the SteamCraft
3.1 both front to back and side to side.
3. Refer to Figure 2-8. Leaving the required clearance (shaded area) around
the unit, determine the exact front, back, and side lines of the SteamCraft
3.1 on the counter top. From these lines, locate and drill four 1/2 inch
diameter mounting holes in the counter, as shown in the diagram.
Top Mounting
Model 21-CET-8 Service Manual
WARNING
INJURY AND EQUIPMENT DAMAGE
from improper lifting. The SteamCraft 3.1 weighs
approximately 135 pounds. Use enough workers with
experience lifting heavy equipment to place the
SteamCraft 3.1 on the counter.
Page 11
could result
Printed 12/90