2-38 Compaq ProLiant DL760 Servers Maintenance and Service Guide
I/O Module
The I/O module is located at the rear of the server. Remove it to replace or service non-hot-plug
components or to access other components in the I/O module.
Removing the I/O Module
To remove the I/O module:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
If the server is rack mounted, the cable management arm must be removed. See the section
"Removing the Cable Management Arm" later in this chapter.
2. Label and remove the cables from the back of the I/O module.
3. Open the top access panel. See "Top Access Panel" earlier in this chapter.
4. Loosen the shipping screw, if necessary. See "Shipping Screw" earlier in this chapter.
5. Push in on the sides of the stop latches
downward
6. Pull the I/O module out of the chassis
Figure 2-31. Partially removing the I/O module
.
1
2
on the I/O module, and rotate the cam levers
until it catches on the module stop latch.
3