Removing The Cable Management Arm - Compaq ProLiant DL760 Maintenance And Service Manual

2-40 Compaq ProLiant DL760 Servers Maintenance and Service Guide

Removing the Cable Management Arm

To remove the cable management arm:
1. Label all cables running through the cable management arm.
2. Disconnect all cables from the rear of the I/O module.
3. Loosen the green thumbscrew that secures the cable management arm and bracket to the
I/O module
4. Move the bracket, with cable management arm attached, slightly up and then back from
the server
Figure 2-33. Disconnecting the cable management bracket from the I/O module
5. Swing the cable management arm to the left and out of the way
Figure 2-34. Rotating the cable management arm to the left
.


so that it is possible to access the cam levers on the I/O module.

2
1
3
.