8. Remove the power switch plate from the media module
Figure 2-17. Removing the power switch plate from the media module
9. Squeeze the grommets around the LEDs, and remove the LEDs from the grommets.
Remove the thermistor from the bracket assembly
10. Pull the switch assembly out of the power switch plate
5
Figure 2-18. Removing the Power On/Standby switch from the power switch plate
Reverse steps 1 through 8 to replace the Power On/Standby switch assembly.
NOTE: The Power On/Standby switch LED is in the top position, and the thermistor is in the bottom
position.
3
4
4
Removal and Replacement Procedures 2-23
.
.
.