2-58 Compaq ProLiant DL760 Servers Maintenance and Service Guide
System Midplane Assembly
The system midplane assembly is the board that the power supply connects to.
To remove the system midplane assembly:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Open the top access panel. See "Top Access Panel" earlier in this chapter.
3. Remove and disconnect all modules and power supplies. See the sections, "Removing the
Media Module," "Removing the I/O Module," and "Hot-Plug Power Supply."
4. Loosen the two thumbscrews securing the system midplane assembly to the chassis
5. Remove the board from the chassis
Figure 2-53. Removing the system midplane assembly
Reverse steps 1 through 5 to replace the system midplane assembly.
.
2
.
1