Removal And Replacement Procedures; Media Module; Removing The Media Module - Compaq ProLiant DL760 Maintenance And Service Manual
Hide thumbs
Also See for ProLiant DL760:
- User manual (229 pages) ,
- Manual (19 pages) ,
- Technology brief (14 pages)
Table of Contents
Advertisement
Media Module
Mass storage in Compaq ProLiant DL760 servers is located in the media module. The media
module is capable of configuring a maximum of four 1-inch hot-plug Wide Ultra2 or
Wide Ultra3 SCSI hard drives. The media module supports two non-hot-plug media drive bays:
I
One third-height drive bay occupied by a 1.44-MB diskette drive
I
One third-height drive bay occupied by a 24X Max (or higher) IDE CD-ROM drive
Removing the Media Module
To remove the media module from the server:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Push in the sides of the cam levers on the media module
downward
1
Figure 2-6. Removing the media module
CAUTION: Removable media blank bezels and hot-plug drive cage blanking panels must be
installed over unused mass storage and removable media device bays to maintain proper
airflow.
.
2
WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal system
components to cool before touching them.
Removal and Replacement Procedures 2-11
and rotate the top of the levers
Advertisement
Table of Contents
