Compaq ProLiant DL760 Maintenance And Service Manual page 42

2-18 Compaq ProLiant DL760 Servers Maintenance and Service Guide
To remove a hot-plug SCSI hard drive:
1. Push the tab to unlock the drive
2. Rotate the hot-plug drive ejector lever outward
3. Pull the hot-plug drive from the drive bay
Figure 2-12. Removing a hot-plug SCSI hard drive
Reverse steps 1 through 3 to replace a hot-plug SCSI hard drive.
CAUTION: Do not turn off an attached disk drive enclosure when the server containing the
Smart Array Controller is powered on. Also, do not turn on the server before turning on the disk
enclosure. If these ordering rules are not followed, the Smart Array Controller may mark the
drives in this enclosure as "failed," which could result in permanent data loss.
CAUTION: Replace a hot-plug SCSI hard drive only when the drive LED is amber. Do not
remove a hot-plug SCSI hard drive if the online LED is green.


.
.

.

3
1
2