2. Squeeze upward on the release tab in the middle of the power supply handle
3. Rotate the power supply handle down
as shown in Figure 2-52.
IMPORTANT: Use only the power supply part number for the Compaq ProLiant DL760 server. Power
supplies from other servers will not fit.
NOTE: When you remove the power supply, a spring-loaded trap door closes to block the opening. This
door preserves the air path required to cool the internal components of the server.
2
Figure 2-52. Removing a hot-plug power supply
Reverse steps 1 through 3 to replace the hot-plug power supply.
and slide the power supply out of the chassis
3
Removal and Replacement Procedures 2-57
.
1