Internal Battery - Compaq ProLiant DL760 Maintenance And Service Manual

Internal Battery

To remove the internal battery:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Open the top access panel. See "Top Access Panel" earlier in this chapter.
3. Locate the battery on the I/O board behind slots 10 and 11.
4. Pull the battery out of the battery socket
Figure 2-50. Removing the internal battery (fan guide and other plastics not shown)
Reverse steps 1 through 4 to replace the battery
WARNING: Your computer contains an internal Lithium cell battery. There is risk of fire and
burns if the battery pack is incorrectly replaced or not handled properly. To reduce the risk of
personal injury, do not attempt to recharge the battery. Do not expose to temperatures higher
than 60°C. Do not disassemble, crush, puncture, short external contacts, or dispose of in fire or
water. Replace only with the Compaq spare designated for this product.
CAUTION: Replace the battery within 15 minutes of removal to avoid data loss.
1
CAUTION: Batteries, battery packs, and accumulators should not be disposed of
together with the general household waste. In order to forward them to recycling
or proper disposal, please use the public collection system or return them to
Compaq, your authorized Compaq Partners, or their agents.
Removal and Replacement Procedures 2-55
.


2
.