Resetting - Extron electronics DSC HD-HD 4K Plus A Series User Manual

Resetting

Resetting the unit causes various settings to revert to the defaults that were set at the
factory. Resets can be performed via the front panel buttons, the rear panel
the OSD, the PCS software, or SIS commands. The following resets are available:
•
•
Mode Activation
1 Hold in the rear panel
while applying power to the unit.
4 Hold in the
Reset
Reset LED blinks twice (once after
approximately 3 seconds and
again after 6 seconds). Then, within
1 second, press
(for less than 1 second).
5 Hold in the
Reset
Reset LED blinks three times (once
after approximately 3 seconds, again
after 6 seconds, and then again after
9 seconds). Then, within 1 second,
press momentarily (for less
Reset
than 1 second).
NOTE: Mode 5 reset clears all adjustments. To save these settings, use the PCS software program
and select
Backup
control program help file for more information).
Factory defaults — This reset clears all user-specified settings but retains the latest
firmware version. You can perform this reset by:
Selecting
• Factory Reset
Factory Reset item
Entering the SIS command to reset all device settings to factory default (see the
•
Resets commands
Selecting
• Reset Device
When the reset is complete, the message
Resetting using the
Reset
summarizes the reset modes that are accessible via the recessed
the rear panel.
Reset Modes Summary
Result
button • Restores the factory-installed default
Reset
firmware version for a single power
cycle.
• Retains all user files and settings,
including audio adjustments, and IP
settings.
button until the • Sets the following to factory defaults:
•
•
momentarily •
Reset
•
• Sets port mapping to the factory
default.
The Reset LED blinks four times in quick
succession during the reset.
button until the Performs a complete reset to factory
defaults except the firmware.
• Does everything that mode 4 does.
• Resets all user-modifiable
configuration to default values,
including IP settings and real-time
adjustments.
• Deletes all user-loaded files, including
user images.
The Reset LED blinks four times in quick
succession during the reset.
from the
DSC HD-HD 4K Plus A
from the submenu of the OSD (see the
Advanced
on the submenu on page 35)
Advanced
on page 64)
from the tab menu in the PCS software
Device
Factory Reset
button — The Reset Modes Summary table
IP address —
192.168.254.254
Subnet mask —
255.255.0.0
Gateway address —
0.0.0.0
DHCP —
Off
tab menu before you perform this reset (see the
DSC HD-HD 4K Plus A Series • Operation
button,
Reset
is displayed on the OSD.
button on
Reset
Purpose and Notes
Use mode 1 to
remove a version
of firmware for
one power cycle if
incompatibility issues
arise.
Mode 4 sets all IP
information to factory
defaults.
It does not replace
any user-installed
firmware.
Mode 5 is useful if
you want to start
over with the default
configuration.
This is equivalent to
the SIS command
.
ZQQQ
41