Resetting The Device - Extron electronics Quantum Ultra User Manual

4.
5.
6.

Resetting the Device

The
page 30) displays the
perform.
Figure 42.
To reset the unit:
1.
2.
Either:
Select the checkbox to automatically assign all IP addresses, or
•
Use DHCP
Enter the addresses in the
•
.
DNS Server
NOTE: The Media Access Code (MAC) hardware address cannot be changed.
If desired, select the tab for the other LAN port and repeat step 4 for it.
When finished, click .
OK
button on the
Reset Device
Reset Device
Reset Device Window
Select the radio button for the type of reset desired:
• Reset Device Settings (Retain TCP/IP Settings and Image Files)
Resets the Quantum Ultra to its factory default settings while keeping the IP
addresses and other settings that have been entered, plus any image files that
have been uploaded. This is the default.
• Reset Device Settings and Delete All Files (Retain TCP/IP Settings)
— Resets the unit to factory defaults and keeps IP address information. All
uploaded image files are deleted and the default image files are restored.
• Reset All Settings and Delete All Files
defaults. All user-uploaded image files are deleted, IP settings are reset to default,
and the default image files are restored.
Click the button located below the radio buttons. The unit resets and reboots.
Reset
Quantum Ultra Videowall Processing System • Operation
,
IP Address Subnet Mask
main window (see
Control Panel
window, on which you can select the type of reset to
— Resets the unit to factory
, , and
Default Gateway
figure 28 on
—
39