Table of Contents
Advertisement
Resetting the SME 100 Using the Rear Panel
The Reset button on the rear panel of the SME 100 is used to reset the SME 100. To select
different reset levels, use a pointed stylus or small screwdriver to press and hold the Reset
button while the SME 100 is running or press and hold the Reset button while applying
power to the SME 100.
ATTENTION:
delete important information and configuration settings. The table on the next page
provides a summary of the reset modes.
NOTES:
•
The reset modes listed in the table on the next page close all open IP and Telnet
connections and all sockets.
•
Each reset mode is a separate reset (not a continuation from mode 1 to
mode 5).
•
Reset mode 2 and 3 are not available for the SME 100.
•
For information on resetting the SME 100 using the web-based user interface, see
the
•
For information on resetting the SME 100 using front panel menu system, see the
"Advanced Config
•
For information on resetting the SME 100 using SIS commands, see
"Resets /
Commands" section.
Mode 1
Press and hold
the Reset button.
Modes 4 and 5
Press and hold for
6 or 9 seconds.
Figure 11.
Review the reset modes carefully. Using the wrong reset mode may
"Reset
Page" section on page 116.
Menu" section on page 36.
Reboot" on page 152 of the
RESET
RESET
Resetting the SME 100
"Command and Response Table for SIS
Apply power
to the SME 100.
Release, then immediately
Reset LED flashes
press and release again. Reset
twice or three times.
LED flashes in confirmation.
RESET
SME 100 • Panels and Cabling
RESET
Release Reset button.
RESET
15
Advertisement
Table of Contents
