Exit Menu; Resetting An Input - Extron electronics DVS 304 User Manual

Using the swap feature
Use the swap feature to switch the active main window input with the current PIP input.
For example if the main window is Input 4 (RGB scaled) and the PIP window is Input 1
(composite), applying the swap command results in Input 1 becoming the main window
and Input 4 the PIP window.
For audio models (DVS 304 A, DVS 304 AD, DVS 304 DVI A, and DVS 304 DVI AD), you
can set audio to follow the main (default) or PIP window. Audio breakaway is not possible
while PIP mode is on; audio must follow either the main window or the PIP window.

Exit Menu

From this submenu, press the Menu button to return to the Start Auto Image menu cycle,
or press the Next button to return to the default cycle.
INPUT 1
COMPOSITE
(Audio models only)
Figure 23.

Resetting an Input

Each input of the DVS 304 scaler can have its parameters, including auto memories, reset
to default values by holding down the specific input button together with the Menu
button, until the input number and Reset message is displayed on the LCD screen.
Default Cycle
2 sec.
OUTPUT
1024 x 768@60
2 sec.
MENU
START AUTO
IMAGE ON IN1
MENU
INPUT
MEMORY
CONFIG
PRESETS
MENU
MENU
PICTURE
IP
CONTROL
CONFIG
MENU
MENU
OUTPUT
ADVANCED
CONFIG
CONFIG
MENU MENU
AUDIO
TO EXIT MENU
CONFIG
PRESS NEXT
MENU
MENU
Exit Menu
NEXT
DVS 304 Series • Operation 23