Table of Contents
Advertisement
You can perform a one-time Auto-Image by the following methods:
•
•
•
•
Changing the Output Resolution and Refresh Rate
In addition to the
resolution and refresh rate include resetting the output rate using the front panel
(see
commands
file).
Custom Rates
In addition to the 42 factory output resolutions, three custom user-defined rates are
available. Using SIS commands or the PCS control program, you can capture the EDID
of the device connected to the HDMI output or to the loop-through connector (see the
Output Scaler Rate SIS commands
no custom EDIDs are defined, these three resolutions and rates default to 720p @ 60 Hz.
The OSD dynamically updates itself based on the current file stored in the custom EDID
slot. For example, if a custom 720p EDID has been uploaded, the OSD would display
C1: 720p @ 60 Hz
Resetting the Output Rate
If an output image cannot be displayed due to an incompatible output rate, you
can use the front panel down arrow
1024x768 @ 60 Hz (XGA or 1080i) and 1280x720 (720p) @ 60 Hz. To set the rate or
toggle between the two available rates:
1.
2.
NOTE:
Power Save Mode
In power save (standby) mode, all non-essential hardware is shut down in order to
conserve power.
•
•
NOTE: The backup and restore functions available through the PCS control software
Front panel button: While the OSD is not displayed, press the Auto-Image ()
button twice. The first press displays the message
OSD. The second press initiates the Auto-Image.
OSD submenus: Select the
the
Quick Setup submenu
SIS commands (see the
Auto-Image commands
PCS software (see the program help file).
Output submenu
Resetting the Output
Rate), SIS commands (see the
beginning on page 47), and the PCS control program (see the program help
.
Ensure that the OSD is closed by pressing and holding Menu for 3 seconds.
Press and hold the
button until a message appears on the display indicating the
new rate (approximately 5 seconds).
On the front panel, the
To enable power save mode, enter the Power Save ON SIS command (see the
Power Save Mode commands
To exit power save mode, either enter the Power Save OFF SIS command or press
any front panel button (if the front panel is locked, this method does not work).
are not accessible while the unit is in power save mode.
Press Auto
/
Auto-Image
Press Enter to Auto-Image
(see page 16) or the
Input submenu
on page 42).
(see page 23), other items for setting the output
on page 47 or the control program help file). When
button to toggle the output rate between
button is labeled Hold
on page 48).
DSC DP-HD A • Operation
to
on the
Confirm
item from
(see page 20).
button
Output Configuration
for XGA
720p.
/
31
Advertisement
Table of Contents
