Table of Contents
Advertisement
Input Presets
The DSC HD-HD 4K Plus A Series scalers have 128 memory slots in which you can save
input presets. These presets allow a matrix switcher with multiple types of video inputs
(such as an XTP) to be placed upstream from the DSC to expand the number of video
sources. Input presets can be saved and recalled only through SIS commands (see the
Input Presets commands
•
•
Values for the following settings are saved in input presets:
•
•
•
•
•
•
Saving a preset when using a matrix switcher
When using the DSC with a matrix switcher, do the following to save a preset:
1.
2.
3.
Locking the Front Panel (Executive Mode)
To prevent access by unauthorized users or accidental changes to the DSC settings, you
can lock the front panel controls by placing the DSC in executive mode. In this mode, all
front panel buttons are disabled and control is available only by SIS commands.
To lock the front panel, do any of the following:
•
•
•
To unlock the front panel, do any of the following:
•
•
•
on page 57).
When you recall an input preset, it fills the output raster based on the sizing and
positioning that it had at the time it was saved.
Input presets can be saved based on one input rate and recalled to a different rate.
This enables presets to be used as aspect ratio or other quick-sizing shortcuts.
Contrast
Brightness
Detail
Film detect
Audio gain and attenuation
Active pixels (H Active)
Switch each input of the matrix to the DSC.
Configure each input: size, position, detail, brightness, and contrast. The remaining
settings (active pixels and lines) are not user-configurable, but are stored automatically
as part of the preset.
Save the settings to a preset for recall by the control system when that matrix input is
routed to the HDMI input.
Press and hold the front panel
message
Executive Mode Enabled
remains on the OSD approximately 2 seconds.
Enter the
SIS command (see the
Enable
commands
on page 63).
Select
Lock Front Panel
the program help file).
Press and hold the front panel
the message
Executive Mode Disabled
remains on the OSD approximately 2 seconds.
Enter the
SIS command (see the
Disable
commands).
Select
Unlock Front Panel
program help file).
•
Active lines (V Active)
•
Horizontal image position
•
Vertical image position
•
Horizontal image size (width)
•
Vertical image size (height)
•
Preset name
and
buttons until the OSD displays the
Menu
(approximately 5 seconds). The message
Front Panel Lock (Executive Mode)
on the
General Settings
and
buttons again until the OSD displays
Menu
(approximately 5 seconds). The message
Front Panel Lock (Executive Mode)
on the PCS software
General Settings
DSC HD-HD 4K Plus A Series • Operation
screen of the PCS software (see
screen (see the
40
Advertisement
Table of Contents
