Extron electronics DSC HD-HD 4K Plus A Series User Manual page 72

Command
Advanced Configuration (continued)
Unsolicited HDCP Statuses
Enable unsolicited HDCP
responses
Disable unsolicited
responses
View unsolicited
responses state
On-Screen Menu Configuration (Front Panel Control Button Emulation)
NOTES:
•
An E13 error code is returned if a navigation button command other than R MENU (right arrow button) is sent while
the OSD menu system is Off.
•
The right arrow command can be used to initiate an Auto-Image, therefore, it does not return an error code.
•
An E14 error code is returned if a menu emulation command is sent while the unit is in front panel lock mode.
•
The unit exits power save mode if a menu emulation command is sent while the DSC is in power save mode.
Toggle menu on and off
Enter menu system
Exit menu system
Enter (select)
Up Arrow
Down Arrow
Left Arrow
Right Arrow
View menu status
Resets
System reset
Absolute system reset
Absolute system reset,
retain IP settings
(Recommended for after
a firmware update.)
X2(
NOTE: = Front panel lock mode (executive mode):
0 = Unlock front panel (default), 1 = Lock front panel
X3)
= OSD menu status: 0 = Off (default), 1 = On (displayed).
X4(
= Unsolicited signal or HDCP status response: 0 = Enabled, 1 = Disabled.
ASCII Command Response
(Host to Scaler) (Scaler to Host)
E }
H 1 NTFY Ntfy H 1
E }
H 0 NTFY Ntfy H 0
E } X4( ]
H NTFY
In verbose modes 2 and 3:
Ntfy H
E }
M MENU Menu M
E }
A MENU Menu A
E }
X MENU Menu X
E }
E MENU Menu E
E }
U MENU Menu U
E }
D MENU Menu D
E }
L MENU Menu L
E }
R MENU Menu R
E } X3) ]
MENU
In verbose modes 2 and 3:
Menu
E }
ZXXX Zpx
E }
ZQQQ Zpq
E }
ZY Zpy
DSC HD-HD 4K Plus A Series • Remote Configuration and Control
Additional Description
Enable unsolicited HDCP status
]
responses from the DSC.
Disable unsolicited responses
]
from the DSC (default).
View state (On-Off) of unsolicited
HDCP status responses.
X4( ]
] Emulate the front panel Menu
button: Toggle the OSD menu
on and off.
Discretely enter the OSD menu
]
system.
] Discretely exit the OSD menu
system.
] Emulate the Enter button
(select a submenu or item)
]
Emulate the
]
Emulate the
] Emulate the t button.
] Emulate the  button.
View the OSD menu On-Off
status.
X3) ]
] Reset all device settings to
factory defaults
Set all device settings plus
]
DHCP and the IP address to
factory defaults. DHCP = Off, IP
address = 192.168.254.254.
Same as absolute system reset
]
except that IP address, subnet
mask, gateway address, DHCP,
and port mapping are not reset.

button.

button.
64