Extron electronics DSC HD-HD 4K Plus A Series User Manual page 61

Command
Input Configuration (continued)
Total Lines
View total lines
Total Pixels
View total pixels
3:2, 2:2, and 24:1 Film Detection
Enable auto detection
Disable auto detection
View film detect setting
HDCP Authorized
HDCP authorized
View HDCP authorized
device status
HDCP Status
View input status
View output status
X!
NOTE: = Input number: 1 or 2 (2 is available on the xi model only)
X@
= Output number: 1 or 2 (2 is available on the xi model only)
X^
= Total lines
X&
= Total pixels
X1)
= Automatic film detection status: 0 = disabled, 1 = enabled (default is 1)
X4$
= Input or output HDCP status: 0 = no sink or source device detected, 1 = sink or source device with HDCP
detected, 2 = sink or source detected with no HDCP
X6^
= HDCP Authorized status: 0 = HDCP Authorized off, 1 = HDCP Authorized on (the input reports as an
HDCP authorized device to allow HDCP input signals). (Default is 1).
ASCII Command Response
(Host to Scaler) (Scaler to Host)
E } X^ ]
1 TLIN
In verbose modes 2 and 3:
Tlin 1*
E } X& ]
1 TPIX
In verbose modes 2 and 3:
Tpix 1*
E }
1*1 FILM Film 1*1
E }
1*0 FILM Film 1*0
E } X1) ]
1 FILM
In verbose modes 2 and 3:
Film 1*
E X6^ }
E 1* HDCP Hdcp E 1*
E } X6^ ]
E 1 HDCP
In verbose modes 2 and 3:
Hdcp E 1 *
E X! } X4$ ]
I HDCP
In verbose modes 2 and 3:
Hdcp I
E X@ } X4$ ]
O HDCP
In verbose modes 2 and 3:
Hdcp O
DSC HD-HD 4K Plus A Series • Remote Configuration and Control
Additional Description
Show total number of lines (
for the input.
X^ ]
Show the total number of pixels
X&
( ) for the input.
X& ]
Enable automatic detection of
]
film mode (3:2, 2:2, and 24:1
pull-down).
] Disable automatic film detect
detection.
View the current film detect
setting (
X1) ]
X6^ ]
Set HDCP Authorized to
View HDCP authorized device
status
X6^ ]
View HDCP status
X!
.
X! X4$ ]
*
View HDCP status
output
X@ X4$ ]
*
X^
)
X10
).
X6^
.
X1)
.
X4$
for input
X4$
for
X@
.
53