7-122 Tray 4 Opened (TTM)
The Tray 4 Feed Out Sensor detected paper when Tray 4 is pulled out and pushed in during a
print.
Initial Actions
•
Check condition and specification of paper in Tray 4.
•
Check the paper path for obstructions and clean the Tray 4 Feed Out Sensor.
•
Check the Tray 4 mechanical operation.
•
Check that Tray 4 is properly closed.
Procedure
Enter
dC330
[008-103] and press Start. Block and unblock the Tray 4 Feed Out Sensor
16.5) by sliding Tray 4 in and out of the machine. The display changes.
Y
N
Press Stop. Check the circuit of the Tray 4 Feed Out Sensor
99-1
RAP for troubleshooting procedure.
Press Stop.
•
Ensure that the connectors shown in the circuit diagram
nected and that the wires are not damaged.
•
Check the machine Shutdown History Report. If there is a history of this failure, replace
the Tray 4 Feed Out Sensor
(PL
16.5).
•
If the problem continues, replace the Tray Module PWB
Figure 1 7-122 RAP Circuit Diagram - Tray 4 Feedout Sensor (TTM)
Initial issue
DC 3535/2240/1632, WC M24
(PL
(Figure
1). Refer to the
OF
(Figure
1) are securely con-
(PL
16.15).
09/03
2-131
Status Indicator RAPs
7-122