Yamaha RS90GTZ Service Manual page 85

FUSE INSPECTION
2. Replace:
• Blown fuse
Replacing steps:
• Set the main switch off.
• When changing
the air filter case. When changing
fuse, remove the side cover (right).
Refer to "COWLINGS" in CHAPTER 3.
• Install a new fuse of the correct amperage.
• Set the main switch on and verify if the elec-
trical circuit is operational.
• If the fuse immediately blows again, check
the electrical circuit.
Item
Main fuse
Fuel injection
system fuse
Ignition fuse
Radiator fan
fuse*
Helmet shield
heater jack fuse
Headlight fuse
Signal fuse
Auxiliary DC
jack fuse
Reserve fuse
Reserve fuse
* For RS90GTZ/RS90LTGTZ
WARNING
Never use a fuse with an amperage other
than that specified. Improvising or using a
fuse with the wrong amperage rating may
cause extensive damage to the electrical
system, cause the lighting, ignition, grip
warmer, signal and meter systems to mal-
function and could possibly cause a fire.
RS90GTZ/RS90LTGTZ
RST90GTZ
2-62
INSP
ADJ
and/or fuse, remove
~
Amperage Q'ty
40 A 1
10 A 1
15 A 1
5 A 1
3 A 1
20 A 1
7.5 A 1
3 A 1
20 A
15 A
7.5 A 1
5 A*
3 A
10 A 1