Yamaha RS90GTZ Service Manual page 491

Insert the projection on each tail
sub-wire harness holder into the
hole in the seat bracket assem-
bly.
Route the tail sub-wire harness
outside of the right backrest
side cover bracket.
Fasten the tail sub-wire harness
at the positioning tape with the
holder.
Passenger grip warmer switch
coupler
Route the passenger
warmer switch lead over the tail
sub-wire harness.
Passenger grip warmer switch
Right passenger grip warmer
lead
Hook the right passenger grip
warmer lead to the holder of the
storage compartment
assembly.
Fasten the tail sub-wire harness
with the holders. After fastening,
make sure that it will not come
loose.
To right passenger grip warmer
Right backrest side cover
Storage compartment
assembly
Pass the plastic band through
the hole in the storage compart-
ment bracket, and then fasten
the tail sub-wire harness with
the band. Install the plastic
band with the buckle facing
inward, making sure that the
end does not contact any other
parts.
Route the tail sub-wire harness
under the storage compartment
bracket.
Insert the projection of the tail/
brake light coupler into the hole
in the storage compartment
bracket.
Storage compartment bracket
To left passenger grip warmer
Left backrest side cover
Fasten the left passenger grip
warmer lead with the holder.
After fastening, make sure that
it will not come loose.
Left passenger grip warmer
lead
grip
lid
lid
9-58
CABLE ROUTING
SPEC