Yamaha RS90GTZ Service Manual page 477

SPEC
CABLE ROUTING
Left grip warmer lead
Brake light switch lead
Brake hose
Helmet shield heater jack lead
Parking brake cable
Corrugated tube (left grip
warmer lead, right grip warmer
lead, grip/thumb warmer adjust-
ment switch lead, headlight
beam switch lead, engine stop
switch lead, throttle switch
leads, thumb warmer lead,
brake light switch lead, and hel-
met shield heater jack lead)
Fit the right grip warmer lead
into the groove in the right han-
dlebar switch.
Right grip warmer lead
Right handlebar switch
Throttle cable
Fasten the right grip warmer
lead, engine stop switch lead,
throttle switch leads, and thumb
warmer lead with the plastic
band, making sure to install the
band around the protective
sleeves of the leads, not the
leads themselves.
Connect one of the left grip
warmer leads to one of the right
grip warmer leads and connect
the remaining two left and right
grip warmer leads to the wire
harness.
Fasten the left grip warmer lead,
grip/thumb warmer adjustment
switch lead, headlight beam
switch lead, brake light switch
lead, and helmet shield heater
jack lead with the plastic band,
making sure to install the band
around the protective sleeves of
the leads, not the leads them-
selves.
Left handlebar switch
Make sure that the helmet
shield heater jack contacts the
left handlebar switch.
Helmet shield heater jack
Cut off the excess end of the
plastic locking tie.
Less than 3 mm (0.12 in)
Top view of rubber cover instal-
lation
Insert the four triangle parts of
the rubber cover into the holes.
9-44