CRANKSHAFT AND BALANCER SHAFT
4. Tighten:
• Balancer weight bolts
TIP
Place a wood
between the balancer weight
and crankcase.
Balancer weight bolt:
35 Nm (3.5 m•kgf, 25 ft•lbf)
5. Bend the lock washer tab.
6. Install:
• Crankshaft journal upper bearings
(into the upper crankcase)
• Crankshaft journal lower bearings
(into the lower crankcase)
TIP
• Align the projections
journal bearings with the notches
crankcase.
• Be sure to install each crankshaft journal
bearing in its original place.
7. Install:
• Bearing
(to the primary sheave drive shaft assembly
)
TIP
Be sure to install the bearing so that its hole
is near the bearing edge that is facing away
from the primary sheave drive shaft assembly.
5-85
ENG
on the crankshaft
in the