Yamaha RS90GTZ Service Manual page 483

Front axle housing
Speed sensor
Nylon nuts
To engine
Primary fixed sheave
More than 5 mm (0.20 in)
Clamp
Water pump inlet hose
Water pump
Flange bolt
Gear unit
Frame cross member
The holder may contact the end
of the frame cross member
pipe.
Speed sensor lead
Wire harness
Position the end of the holder
near the end of the frame cross
member bolt.
Install the relay on any position.
(RS90GTZ/RS90LTGTZ)
Radiator fan motor
(RS90GTZ/RS90LTGTZ)
Headlight relay
(RS90GTZ/RS90LTGTZ)
Load control relay (RS90GTZ/
RS90LTGTZ)
Fuel injection system
(RS90GTZ/RS90LTGTZ)
Insert the projection of the plas-
tic band into the frame and fas-
ten the wire harness and speed
sensor lead with the plastic
band. (RS90GTZ/RS90LTGTZ)
Fasten the wire harness and
speed sensor lead with a plastic
band. (RST90GTZ)
Fasten the wire harness and
speed sensor lead with a plastic
band as shown in the illustra-
tion. (RST90GTZ)
relay
(black)
relay
9-50
CABLE ROUTING
SPEC