Removing The Protective Film From The Exposure Unit Conveyer - Konica Minolta DRYPRO 771 Installaton Manual

Ch.2 Unpacking and Installation
2.4.4 Removing Protective Film from the exposure unit Conveyor
After removal of the protective parts from the front panel of the exposure unit, the two protective films
(14x17in) should be removed from the exposure unit conveyor rollers.
DRYPRO MODEL 771 INSTALLATION MANUAL Ver.1.00 2003.10
1
Press lever-BC down and open the left cover.
B C
2
Remove the tape that secures the protective film
for transport rollers of the exposure unit to the
main body.
• The protective film for transport rollers of the
exposure unit is pinched between the transporter
rollers of the exposure unit.
3
Push toward the left cover, two protective films
for transport rollers of the exposure unit, which
is pinched between the transport rollers.
• The two sheets of film are pressed together
between the rollers.
4
Remove the jammed film from the descent
transport section.
5
Close the left cover.
• Next, remove the protective parts from the supply
section.
< 34 >