Removing And Reinstalling Of The Finisher Unit; Removing And Installing Of The Tray - Konica Minolta FS-107 Service Handbook

DISASSEMBLY/ASSEMBLY
Caution: Make sure the power plug is taken
out of the socket.
[1] Removing and reinstalling of the
1
finisher.
(1) Open the front door, then insert a pen, or the like,
into the hole at the bottom of the finisher.
Caution: There is a risk of the internal lever becoming
1
deformed, so do not push it in hard.
(2) Pull the finisher forward and remove it.
[2] Removing and reinstalling of the tray
1
(1) Take out each 3 sets of set screws and remove the
cover's front and rear.
Set screws
Cover (rear)
REVISED EDITION
1
Set screws
Cover (front)
Set screws
DATE
May 2000
(2) Take out each 2 sets of set screws from the wire
fittings on front and rear.
Set
screws
(3) Pull out the tray downward from the frame that it is
installed.
Caution 1: Taking out the set screws from the fixed
fittings will make the tray frame fall out.
Caution 2: Take care not to drop the rollers installed
on the tray.
1
PAGE
3-1
3-1
FS-107
Set
screws
Wire fittings
Rollers
METHOD
REPLACEMENT