Attaching The Outer Covers - Konica Minolta DRYPRO 771 Installaton Manual

Ch.2 Unpacking and Installation
2.4.9

Attaching the Outer Covers

Attach the outer covers after completing the removal of protective parts.
DRYPRO MODEL 771 INSTALLATION MANUAL Ver.1.00 2003.10
1
Replace the heat processing cover to the
original position, and secure it with four screws (TP
screws, M3x6).
•
Hold the both side, and attach the heat processing
cover as illustrated in the left.
2
If the drum shaft cover is separated from the
heat processing cover, attach the drum shaft
cover.
3
Attach the cover originally attached to the front of
the heat processing cover.
•
Use one screw to secure.
4
Attach the top cover.
•
Secure the right and left covers with two screws
each, and tighten the screw for the rear cover,
which was loosened in the procedure before.
< 41 >