Print Commanded From The External Device; Backup - Konica Minolta DRYPRO 771 Installaton Manual

Ch.5 Print Commanded from the External Device and Backup
5.1

Print Commanded from the External Device

The procedure for connection of DRYPRO 771 power supply and network cables is described below.
DRYPRO MODEL 771 INSTALLATION MANUAL Ver.1.00 2003.10
1
Connect one end of the ethernet cable to the
ethernet port (RJ45) located on the rear panel of
the DRYPRO 771.
• The other end of the cable should be connected to
the facility network hub.
2
Send the print queue from the external device,
and check the print is carried out without failure.
• If any error occurs, refer to "Troubleshooting" of
the Service Manual, and remedy the problem.
• Proceed to the step-3 when the print is successful.
3
Secure the network cable with the accessory
clamps (2pcs) considering the installation space
and environment.
< 90 >