Konica Minolta DRYPRO 771 Installaton Manual page 53

Ch.2 Unpacking and Installation
Do not touch the knob on the light-
blocking cover. Doing so may expose the
film to light.
1
2
.
Please set new film
and close the tray
Now winding .
the film envelope
14x17 B S:126 Q:000.
WARM UP
14x17 B S:126 Q:000.
READY
DRYPRO MODEL 771 INSTALLATION MANUAL Ver.1.00 2003.10
6
Insert the top edge (far edge) of the package
firmly between the restrainer and winding axis.
7
Ensure that the bottom edge (near edge) of the
package protrudes from the light blocking cover
and firmly close the light-blocking cover.
8
Take the cutter out of the cutter pocket.
(Illustration-1 at left)
9
Use the cutter to cut the protruding edge of the
package.(Illustration-2 at left)
10
Return the cutter to the cutter pocket.
11
Push the supply tray back in until it locks into
position.
• After the supply tray has been locked into position, the
message "Now winding the film envelope" will be
displayed.
• One sheet of film printed with the automatic density
correction calibration pattern will be ejected.
< 51 >
After completion of the
film loading process,
the value shown in the
"number of sheets"
column of the loaded
film information display
will change from "0" to
"126."