Konica Minolta DRYPRO 771 Installaton Manual page 65

Ch.3 Settings
• S2F REQ. BEHAVIOR
• S2G FLIP
Stamp Position and Orientation
With the reference to the density patch that is positioned up, the four positions of stamp and orientation is
described.
14x17 PORTRAIT
14x14 PORTRAIT
11x14 PORTRAIT
Density Patch
DRYPRO MODEL 771 INSTALLATION MANUAL Ver.1.00 2003.10
: Select the action when the image size sent from the connected device is larger
than the installed film size.
Select from "DECIMATE" (proportional display) and "CROP" (length display).
Selecting "DECIMATE" prints a reduced image by fitting the image size to the
film. The reduction ratio will be printed on the output film.
Selecting "CROP" does not reduce the image, but trim the excess of the image
for the print to fit to the film. The trimmed amount in length will be printed on the
output film.
default setting : DECIMATE
: This setting determines whether display shall be highlighted.
"ON" or "OFF" may be selected.
default setting : OFF
UPPER
LOWER
UPPER
LOWER
UPPER
LOWER
LANDSCAPE
LANDSCAPE
LANDSCAPE
< 63 >
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT