Caution Relating To Installation - Konica Minolta DRYPRO 771 Installaton Manual

Preface
Cautions Relating to Installation
The field service engineer should become familiar with the following precautions before proceeding with
installation work.
1. To avoid accidents, only personnel properly trained and authorized by the manufacturer should remove covers
or touch internal parts.
2. The DRYPRO 771 incorporates a laser beam device (Class 3b). Direct exposure of the skin or eyes to the laser
beam may cause serious damage. Always use protective goggles when carrying out repairs or adjustments.
3. Under no circumstances should any attempts be made to carry out operational procedures or adjustments other
than those described in this manual: exposure to harmful radiation may result.
4. To ensure safety while using or working on the DRYPRO 771, cautions shown on warning labels must be
observed at all times.
5. The DRYPRO 771 contains internal parts that carry high voltage that may cause electrocution if touched.
Extreme caution must be exercised at all times.
6. Be careful to avoid parts of the body or clothing becoming trapped or entangled in moving parts such as fans.
7. The DRYPRO 771 weighs approximately 155kg(without stand) / 175kg (with stand).
Ensure that there is sufficient work space when carrying out unpacking or installation work.
8. Electrical circuitry in the DRYPRO 771 may be damaged by static electricity. Due care must be exercised when
handling the main body or any electrical parts removed during repair work.
9. The DRYPRO 771 power supply must be switched off when removing circuit boards, disconnecting or
connecting connectors or cables. Under no circumstances should such procedures be carried out with the
power supply switched on: doing so may result in serious accidents.
10. A wrist band must always be worn when handling circuit boards.
11. The DRYPRO 771 incorporates a lithium battery. Improper replacement of the battery may cause damage: only
a qualified service engineer may carry out this procedure.
12. The DRYPRO 771 is a Class-1 laser device furnished with interlocks. The procedures described in this manual
must be followed when disengaging interlocks.
13. Be certain to comply with any and all laws and government regulations including electric codes and utility
regulations, regarding the installation and operation of this equipment.
DRYPRO MODEL 771 INSTALLATION MANUAL Ver.1.00 2003.10
< 2 >