Konica Minolta DRYPRO 771 Installaton Manual page 47

Ch.2 Unpacking and Installation
2.5.2 Changing Supply Tray Film Size
In cases where the film size used at the facility is either 14 X 14 inch or 14 X 11 inch, the position in which
the supply size stopper is set must be changed.
l The supply size stopper set at the factory is for 14 x 17in.
Supply tray open button
11x14
14x14
Do not remove
these two.
4
5 6
Destination Original Pos.
DRYPRO MODEL 771 INSTALLATION MANUAL Ver.1.00 2003.10
1
Press the supply tray open button on the rear
panel of the DRYPRO 771 and open the supply
tray.
2
Pull the tray out to its furthest extent and open the
light blocking cover.
3
Remove the side stopper screws (M4x8, two in
17x17
front and rear) from the original position.
4
Remove the screws (M4x8, two in front and
rear) from the destination position.
5
Move the size stopper to the required film size
position and screw into place with the screws
removed in the step-3.
3
6
Attach the two screws (M4x8) removed in the
step-4 into the original position.
• The screw holes at the original position are
blocked, thus preventing the external light to leak in.
< 45 >
Make sure all screws
once removed are
installed.
Failure to install all may
cause fogging of the film.