1.2.2 Expansion Port Configuration - Konica Minolta DRYPRO 771 Installaton Manual

Ch.1 Before Installation

1.2.2 Expansion Port Configuration

Conditions
In expansion port configuration, 3ch of basic configuration and expansive 5ch, total of 8 ch can be connected.
The expansion port configuration of 5ch is enabled by allocating maximum 5ch to the 1 channel of the basic
configuration, thus conditions listed below should be applied to the device connecting to this channel.
1. Available expansion channels : 5ch
2. Connectable device type
3. Processing capacity
4. Limitation of setting
5. Preparation
Settings
Normally when setting the "DICOM PRINT", it is essential to set "Port No." + "IP Address" + "AE Title".
However, it is possible to allocate 1ch to the DRYPRO 771 disregarding the AE title. (use "S09 DEFAULT
CH" to select and set the channel that is allocated to the expansion port)
Using this expansion port, maximum 8 channels can be connected. Leave blank for the AE title inputbox for
both expansion port and device that is connected to the expansion port.
Ex) Basic 3ch + Expansion 5ch
CS-1 Printlink2
Ex) Basic 3ch + Expansion 5ch (2 units for backup)
CS-1 Printlink2
Basic
Backup
DRYPRO MODEL 771 INSTALLATION MANUAL Ver.1.00 2003.10
: KDIS devices (RS Series, IS Series, Liteview)
REGIUS Series (only for back up set up)
: Devices that process maximum 20 sheets of film per day.
: On the device connected to the expansion 5ch, it is not possible to set
LUT or PRINT CONDITION ("S20", "U30") for each device. For these
devices, settings are limited to "LUT fixed" and common use of "PRINT
CONDITION ("S20", "U30")" for each device.
: When setting the expansion port configuration, request and obtain the
system configuration diagram from the sales representative in charge
of the client.
REGIUS IM LiteView Liteview
CH1 CH2 CH3 CH4
Expansion
Port
DRYPRO 771
REGIUS IM CS-1 LiteView Liteview
CH1 CH2 CH3 CH4
Expansion
Port
DRYPRO 771
Liteview Liteview Liteview
Liteview CS-1 CS-1
CH1 CH2 CH3 CH4
DRYPRO 771
< 12 >