Konica Minolta DRYPRO 771 Installaton Manual page 50

Ch.2 Unpacking and Installation
2.5.5 Installing the Exhaust Duct
How to install the exhaust duct is detailed below. This duct should be installed according to the requirement.
Installation of the exhaust duct can drive the exhaust flow downward as well as decrease the exhaust fan
noise.
2.5.6 Attaching the Onetouch Spacer (cable protection parts) (option)
How to attach the cable protection parts are detailed below. These parts should be attached according to the
requirement. Attaching the cable protection parts will protect the network cable from damage caused by
being caught in between the rear panel and the wall.
DRYPRO MODEL 771 INSTALLATION MANUAL Ver.1.00 2003.10
1
Take out the exhaust duct from the accessory
box delivered with the packing.
2
Remove two screws that are preattached to the
securing position for the exhaust duct on the
rear panel of the unit.
3
Attach the exhaust duct on the rear of the unit, and
fix it using two screws.
1
Take out the cable protection parts (2 pcs) from the
accessory box delivered with the packing.
2
Insert the black, protruding part of the parts into the
installation hole on the rear panel of the unit,
and push in the white button using a tip of screw
driver, etc..
• Cable protection parts will be secured at the
position.
< 48 >
When the cable
protection parts
(spacers) are not
attached, films will not
get fogged even the
installation holes are
not blocked.