Result Codes - Paradyne Comsphere 3830 User Manual

AT Command Set and
Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Operating Modes
Switching Between Data Mode and Online Command Mode
Escape Sequence and Escape Guard Time
Command Guidelines
Result Codes
AT Command List
S-Register List
Overview
This chapter discusses guidelines necessary to operate AT commands
as well as listing all AT commands supported by the Model 3830
modems. AT commands are issued from asynchronous DTEs.
Operating Modes
The Model 3830 modem has two operating modes: Command mode
and Data mode. Before a modem goes online (establishes a successful
connection with a remote modem), it is considered to be in Command
mode, an idle state where you can modify its operating parameters or
issue modem commands. (Any command issued is acknowledged with
a response in either words or digits known as result codes. Refer to
Table 4-1 for a listing of result codes.)
Once the modems are online, either by answering or originating a call,
they automatically switch to Data mode. Data mode is a state where
any entries made from the DTE are considered data and are transmitted
and received between modems. The modems remain in Data mode until
the connection is broken or until they are forced into online Command
mode using the escape sequence (+ + +).
3830-A2-GB91-20
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
November 1996
S-Registers
. . . . . . . . . . . . . . . . . . . . . .
4
4-1
4-1
. . . . . . . . . 4-2
4-2
4-3
4-4
4-6
4-28
4-1